Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » how to remove fuel tank vent ford
Viewing all articles
Browse latest Browse all 10

Ford Focus Fuel Tank Installation Instructions

$
0
0

The Ford Focus is among the many newer additions to Ford’s automotive arsenal. The Focus is taken into account a cosmopolitan automotive with an international enchantment for each American and European buyers. Installing a Fuel Tank into all Focus models is straightforward enough for anyone to do in whatever part of the world. Study what procedures it is advisable to observe to make sure correct Fuel Tank installation.

Ford Focus Fuel Tank Installation Instructions>/h3>
1. Take off the fuel filler cap and disconnect the damaging automobile battery cable. Put in a siphoning hose to empty the fuel out of the gas tank into an approved container; set the container aside.
2. Put the automobile on a jackstand and remove the car’s rear wheel nuts with a torque wrench. Take off the wheels. Remove all wires and fuel hoses from the gasoline tank. Unhook the tank straps and take away the tank bolts. Decrease the tank to the bottom with a floor jack.
3. Inspect your fuel tank rigorously before positioning it underneath your Focus’ trunk. Connect the gas strains to the top portion of the tank, and connect the fuel pump/gauge sender wiring plug positioned on the prime left facet of the fuel tank. Examine the plug to confirm that all the wiring is in place before continuing to put in your fuel tank.
4. Hook the tank straps across the fuel tank and put the tank strap bolts on each finish of the tank to carry it to the car’s body. Place the fuel return line into the connector slot right subsequent to the fuel filter and connect the fuel supply hose back onto the fuel filter to maintain the gasoline inside your fuel tank.
5. Reattach the filler pipe and vent hoses back onto the fuel tank. Install the exhaust system mounting rubbers at the back and front of your Focus. Restore the exhaust warmth protect, situated at the rear of the automotive near the exhaust pipe. Use a screwdriver to screw within the exhaust flange nuts behind the bendable a part of the exhaust pipe’s front to keep it on the automotive’s body.
6. Set up the automobile’s rear wheels back onto your Focus. Tighten the rear wheel nuts with a torque wrench as a lot as doable or until the wheel nuts can’t flip any further. Refill your fuel tank with the gas out of your fuel container and then join the destructive battery cable.
7. Restore stress to your tank by putting on the fuel filler cap. Verify your automobile for any leaks or free wiring. If you don’t see anything, take a drive to check how it runs with the brand new fuel tank.


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images